Thanks for the detailed answers. I missed this last one for some reason (!)
I believe I have fixed the issue by : IN RME Babyface Assign; Main Out to AN 1/2, and Phones to None. In Bitwig I have Main Out 1+2 as Headphones so I then get to monitor via Headphones (no speakers).
Then : In TotalMix FX on the PH 3/4 Hardware Output tab I have The PH 3/4 fader all the way up, and in Software Playback I have the DAW sounds fader all the way up and the ADAT 3/4 fader (where the RME XLR outs are routed) all the way down.
On the "Main" tab, on Software playback I have the ADAT 3/4 fader up. Everything else is down.
This way I do not hear the direct XLR outputs (the unaffected sound) so do not get the doubling of the sound.
I do hear the affected sound from the Microcosm - although on the Hardware Inputs that fader (for the RME inputs (from Microcosm) is all the way down.
So I am not sure I am yet FULLY understanding the whys - which is a bit disturbing
- but it does appear to work. Does this sound correct?
This doesn't seem to be the same as your suggested solution above. I will check out the manual as you mention above.
I believe I have fixed the issue by : IN RME Babyface Assign; Main Out to AN 1/2, and Phones to None. In Bitwig I have Main Out 1+2 as Headphones so I then get to monitor via Headphones (no speakers).
Then : In TotalMix FX on the PH 3/4 Hardware Output tab I have The PH 3/4 fader all the way up, and in Software Playback I have the DAW sounds fader all the way up and the ADAT 3/4 fader (where the RME XLR outs are routed) all the way down.
On the "Main" tab, on Software playback I have the ADAT 3/4 fader up. Everything else is down.
This way I do not hear the direct XLR outputs (the unaffected sound) so do not get the doubling of the sound.
I do hear the affected sound from the Microcosm - although on the Hardware Inputs that fader (for the RME inputs (from Microcosm) is all the way down.
So I am not sure I am yet FULLY understanding the whys - which is a bit disturbing

This doesn't seem to be the same as your suggested solution above. I will check out the manual as you mention above.
Statistics: Posted by Ultrabra — Mon Oct 28, 2024 6:10 am